Zone Charts

The charts display information for all zone traffic on devices.

The following Zone Charts are displayed when a standalone detector and a mitigator is selected:

• Packets per second (PPS)
• Bits per second (BPS)

For more information on east-west traffic, see DDoS Incidents page.

In addition to the above charts, the protocol indicator charts are displayed depending on the type of zone service selected. For example, the following indicator charts are displayed when you select an HTTP service.

• Packet Rate
• Bit Rate
• Packet Drop Rate

• Frag Packet Rate

• Packet Drop Ratio

• Bytes to Bytes From Ratio

To access the TPS Charts page, navigate as follows:

1. Navigate to Monitoring > Charts > Zone Charts.
2. Select a zone from the Zone drop-down list.
3. From the Service drop-down list, select one of the zone services from All Destination Services, Zone Service, or Zone Source Service.

NOTE:

If zone source service is selected, the Protocol Indicators Detection section is masked.

4. From the Device drop-down list, select a TPS detector or a TPS mitigator to view the traffic flowing through the device or select All Mitigators to view the total traffic flowing through all mitigators for that zone. The drop-down lists the TPS devices.

5. From the Duration drop-down list, select a period.

   Following are the periods - Last 5 minutes, Last 15 minutes, Last 1 hour (default), Last 6 hours, Last 24 hours, Last 7 days, Last 30 days, or Custom Range.

   If Custom Time is selected, the Start Time and End Time are enabled. Select the start time and end time in the respective fields and click Apply.