Configure Detection

To configure a detector, do the following:

1. Go to Devices >> Device List .

2. For the TPS device that you wish to configure as a detector, under Actions, click Details and select Configure Detection.

   General Settings

   Under General Settings, the name of the device and detector type is displayed by default.

   Detector xFlow Settings

   Table 146 : Information on Detector xFlow Settings

   Field	Purpose
   sFlow Receiving Port	Enter a port that is used to receive the sFlow traffic which needs to be monitored.
   NetFlow Receiving Port	Enter a port that is used to receive NetFlow traffic which needs to be monitored.
   Detection Window Size	Enter an xFlow sample receiving interval.
   Initial Learning Interval	Enter an initial learning period to understand the traffic patterns.

3. Add the Remote Agents information to determine the routers from where xFlow samples are sent. Click + and add the following information:

   Table 147 : Information on Remote Agents

   Field	Purpose
   Agent name	Enter the name of the router. For example, edge-router-ax2500.
   IP Address	Enter the IP address of the router.
   sFlow	Select the flow technology that the detector supports.
   Netflow	Select the flow technology that the detector supports.
   Netflow Sampling Rate	If Netflow is selected as the flow technology, set the sampling rate of packets. For example, if the sampling rate is 1, every packet is sampled for the detection process.

4. Click Submit.